Advertisement
CRAFTAP 3
Brief Manual on foamy
beverages dispensing
!
а
Make sure that the dispenser is ready for use:
a. is connected to the power supply
and the backlight lamps are on;
b. the gas supply valve on the container is open;
c. the cooler is on (if being used);
а
1
a. Turn the adjusting assembly knob clockwise
until it is in line with the mark on the base;
b. lower the bottle tray if necessary, depending
on the height of the beverage container;
To lower the tray, turn the cam clockwise with
one hand until it stops and, while holding the
dish-shaped part of the tray with the other hand,
shift it down.
To raise the tray, pull it up holding it with your
fingers from underneath.
Detailed instructions and assembly video are available at http://beerinnovations.com
c
b
b
Cam
d
e
d. the dispensing assembly handle is upright;
e. the flow control valve is turned all the way
clockwise;
f. adjust the assembly handle by turning
it as far counterclockwise as possible.
c
c. place the beverage container in the center
of the bottle tray;
d. while holding the beverage container with one
hand, raise the tray until the neck of the beverage
container comes into contact with the rubber gasket.
To avoid hand injury, when lowering the
bottle tray:
• do not hold the shaft with your hand.
• do not put your fingers above the cam
stopper when turning the cam.
beerinnovations.com
f
d
1
Advertisement
