Raven SmarTrax Installation Manual page 16

Chapter 3
Node Cable Installed on Node
FIGURE 6.
Install the two large, rectangular connectors of the node harness (P/N 115-4001-032) into the correct ports
3.
of the node, tightening the bolts on the connectors to secure the connections.
CAN Connector Installed on Machine's CAN System
FIGURE 7.
Locate the machine's existing CAN system behind the left-rear corner of the seat under the wiring panel.
4.
Disconnect the machine's 4-pin Deutsch CAN connectors.
5.
Install the 18" CAN tee adapter cable (P/N 115-0172-068) between the machine's CAN connectors.
6.
Route and connect the remaining end of the tee adapter cable to the node harness (P/N 115-4001-032)
7.
CAN connector.
12 Case IH Patriot 3230/3320/3330 - Steering Ready SmarTrax™ Installation Manual