Inventory - Grizzly G0725 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Jointer Inventory (Figures 6–7 )
A. Jointer Bed Assembly................................. 1
B. Fence.......................................................... 1
C. Dust Collection Bag .................................... 1
D. Limit Block .................................................. 1
E. Push Blocks ................................................ 2
F.
Fence Tilting Handle .................................. 1
G. Fence Bracket Assembly ............................ 1
H. T-Handle Torx Driver T-30 .......................... 1
I.
Fence Sliding Handle ................................. 1
J.
Fence Support ............................................ 1
K. Locking Plate Assembly ............................. 1
L. Dust Chute ................................................. 1
M. Dust Collection Bag Clamp ........................ 1
N. T-Handle Hex Wrench 4mm ....................... 1
O. Hex Wrench 6mm ....................................... 1
P.
Hex Wrench 5mm ....................................... 1
Hardware (Not shown)
—Cap Screws M8-1.25 x 20 ............................. 2
—Lock Washers 8mm ....................................... 2
—Cap Screws M6-1 x 20 .................................. 2
—Lock Washers 6mm ....................................... 2
Model G0725 (Mfd. Since 02/20)
Qty
Figure 6 . Large components.
P
O
N
M
L
J
Figure 7. Small components.
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
A
B
C
E
K
G
H
I
NOTICE
D
F
-13-