Grizzly G0725 Owner's Manual page 18

3. Attach the fence sliding handle to the lock-
ing plate assembly. Secure the locking plate
in position by tightening the fence sliding
handle, as shown in Figure 13.
Locking Plate
Assembly
Figure 13. Securing the locking plate assembly
with the fence sliding handle.
4.
Press down on limit plate tab on fence
assembly, and insert limit block with notched
side facing upward (see Figure 14).
5.
Use (2) M6-1 x 20 cap screws and (2) 6mm
lock washers to attach fence to fence bracket
assembly (see Figure 14).
Cap Screws
x 2
Bracket
Assembly
Limit Block
Figure 14. Attaching fence to fence bracket
assembly.
-16-
Fence Sliding
Handle
Fence
Plate
Limit
Plate
Tab
6. Slide the fence bracket assembly onto the
support dovetails, as shown in Figure 15.
Fence Bracket
Assembly
Figure 15. Fence bracket assembly positioned
over dovetails.
7.
Install the fence tilting handle by threading
the handle shaft into the bracket assembly,
as shown in Figure 16.
Bracket
Assembly
Fence Tilting
Handle Shaft
Figure 16. Installing the fence tilting handle.
8.
Slide the fence forward until it contacts the
cutterhead guard. The guard should com-
pletely cover the cutterhead, as shown in
Figure 17.
Fence
Jointer
Tables
Figure 17. Fence positioned over the jointer
tables.
Model G0725 (Mfd. Since 02/20)
Support
Dovetails
Locking
Plate
Assembly
Fence Tilting
Handle
Cutterhead
Guard