Identification - Grizzly G0725 Owner's Manual

A B
G
Figure 1. G0725 identification (front).
A. Outfeed Table
B. Cutterhead Guard
C. Fence
D. Infeed Table
E. Depth-of-Cut Adjusting Knob
F.
ON/OFF Switch w/Disabling Key
G. Dust Port
For Your Own Safety, Read Instruction Manual Before Operating Jointer
a) Wear eye protection.
b) Always keep cutterhead and drive guards in place and proper operating condition.
c) Always use hold down/push blocks for jointing material narrower than 3 inches, or planing
material thinner than 3 inches.
d) Never perform jointing or planing on pieces shorter than 8 inches.
Model G0725 (Mfd. Since 02/20)

Identification

C
D
E
F
Figure 2. G0725 identification (rear).
H. Fence Bracket Assembly
I.
Fence Tilting Handle
J.
Fence Sliding Handle
H
I
J
-3-