Removing The Hard Disk Drive - Clevo NH77DBQ Service Manual

Removing the Hard Disk Drive

The hard disk drive can be taken out to accommodate other 2.5" serial (SATA) hard disk drives with a height of 7mm
(h). Follow your operating system's installation instructions, and install all necessary drivers and utilities (as outlined in
Chapter 4 of the User's Manual) when setting up a new hard disk.
Hard Disk Disassembly Process
1. Turn off the computer, and remove the battery
2. Remove the SD card cover
angle as shown (Figure 3a).
3. Open it up with the LCD on a flat surface, release the bottom case
)
3b .
4. The HDD will be visible at point
5
a.
3
2
1
14
15
13 12
11
c.
20
(page 2 - 5).
and screws - . Note that screws
6 1 2 16
on the mainboard (Figure 3c
20
6
7
4
16
5
8
9
10
17
& should be remove at a 30 degree
5 6
at points and and remove it
17 18 19
) .
6
b.
17
Disassembly
Figure 3
HDD Assembly
Removal
a. Remove the SD card
cover and screws.
b. Remove the
case.
c. Locate the HDD.
(Figure

19
18 17. Bottom Case
• 15 Screws
Removing the Hard Disk Drive 2 - 7
bottom