Removing The Hard Disk Drive - Clevo W670SHQ Service Manual

Removing the Hard Disk Drive

The hard disk drive can be taken out to accommodate other 2.5" serial (SATA) hard disk drives with a height of 9.5mm
or 7mm (h). Follow your operating system's installation instructions, and install all necessary drivers and utilities (as
outlined in Chapter 4 of the User's Manual) when setting up a new hard disk.
Hard Disk Upgrade Process
1. Turn off the computer, and remove the battery
2. Locate the component bay cover and remove screws
3. Lift the component bay cover
lems using a finger to do this, then use a non-abrasive, non-sharp object (e.g. a coin) to lift the cover up before
removal).
a.
(page 2 - 5).
- (Figure 3a
1 2
off the computer case by applying pressure at points
3
4
2
3
)
.
& ; if you have prob-
4 5
5
1
Removing the Hard Disk Drive 2 - 7
Disassembly
Figure 3
HDD Assembly
Removal
a. Remove the screws. Lift
the component bay cov-
er off the computer.

3. Component Bay
Cover
• 2 Screws