Led Indicators; Auto Mdi/Mdi-X Connection - Weidmuller IE-SW-BL06-4PoE Series Hardware Installation Manual

ATTENTION
To actively update DIP switch settings, power off and then
power on the Ethernet Switch.

LED Indicators

The front panel of the Ethernet Switch contains several LED indicators.
The function of each LED is described in the following table.
LED Color
PWR1 AMBER
PWR2 AMBER
AMBER
10/100M
GREE
N
100M GREEN
PoE+ AMBER

Auto MDI/MDI-X Connection

The Auto MDI/MDI-X function allows users to connect the Ethernet
Switch 10/100BaseTX ports to any kind of Ethernet device, without
needing to pay attention to the type of Ethernet cable being used for the
connection. This means that you can use either a straight-through cable
or cross-over cable to connect the Ethernet Switch to Ethernet devices.
State
Power is being supplied to power
On
input P1.
Power is not being supplied to
Off
power input P1.
Power is being supplied to power
On
input P2.
Power is not being supplied to
Off
power input P2.
TP port's 10 Mbps link is active.
On
Data is being transmitted at 10
Blinking
Mbps.
TP Port's 10 Mbps link is inactive.
Off
TP port's 100 Mbps link is active.
On
Data is being transmitted at 100
Blinking
Mbps.
TP Port's 100 Mbps link is inactive.
Off
FX port's 100 Mbps link is active.
On
Data is being transmitted at 100
Blinking
Mbps.
FX Port's 100 Mbps link is inactive.
Off
Power is being supplied to Powered
On
Device (PD)
Power is not being supplied to
Off
Powered Device (PD)
12
Description