Redundant Power Inputs; Dip Switch Settings; Led Indicators - Weidmuller IE-SW-BL05 Series Hardware Installation Manual

Redundant Power Inputs

Both power inputs can be connected simultaneously to live AC/DC power
sources. If one power source fails, the other live source acts as a backup, and
automatically supplies all of the Ethernet Switch's power needs.

DIP Switch Settings

IE-SW-BL05/08 DIP Switches
DIP Switch Setting
Serves no function (reserved for future use).
------
ON Enables broadcast storm protection
BSP (1)
OFF Disables broadcast storm protection
ATTENTION
To actively updated DIP switch settings, power off and then power
on the Ethernet Switch.

LED Indicators

The front panel of the Ethernet Switch contains several LED indicators. The
function of each LED is described in the table below.
LED Color State
On Power is being supplied to power input P1.
P1 AMBER
Off Power is not being supplied to power input P1.
On Power is being supplied to power input P2.
P2 AMBER
Off Power is not being supplied to power input P2.
On TP port's 10 Mbps link is active.
10M Yellow Blinking Data is being transmitted at 10 Mbps.
Off TP Port's 10 Mbps link is inactive
On TP port's 100 Mbps link is active.
Blinking Data is being transmitted at 100 Mbps.
100M GREEN
Off 100Base TP Port's link is inactive.
The default setting for each DIP Switch is OFF.
The following table explains the effect of setting
the DIP Switches to the ON positions.
Description
Description
- 11 -