Wall Mounting (Optional) - Weidmuller IE-SW-BL06-4PoE Series Hardware Installation Manual

Wall Mounting (optional)

For some applications, you will find it convenient to mount the IE-SW-
BL06-4PoE switch on the wall, as shown in the following figures.
STEP 1: Remove the
aluminum DIN-Rail
attachment plate from the
switch rear panel, and then
attach the wall mount
plates as shown in the
diagram at the right.
STEP 2:
Mounting the switch on the wall requires 4 screws.
Use the switch, with wall mount plates attached, as a
guide to mark the correct locations of the 4 screws.
The heads of the screws should be less than 6.0 mm
in diameter, and the shafts should be less than 3.5
mm in diameter, as shown in the figure at the right.
NOTE Before tightening the screws into the wall, make sure the screw
head and shank size are suitable by inserting the screw into
one of the keyhole-shaped apertures of the wall mounting
plates.
Do not screw the screws in completely—leave about 2 mm to
allow room for sliding the wall mount panel between the wall
and the screws
STEP 3:
Once the screws are fixed on the wall, insert the four screw heads
through the large parts of the keyhole-shaped apertures, and then slide
the switch downwards, as indicated. Tighten the four screws for added
stability.
7