Dip Switch Settings; Led Indicators - Weidmuller IE-SW-VL08-8GT Hardware Installation Manual

If neither of these two conditions occurs, the Fault circuit will be closed.

DIP Switch Settings

The default setting for each DIP switch is OFF. The
following table explains the effect of setting the DIP
switches to the ON positions.
DIP Switch Setting
ON Enables broadcast storm protection
BSP
OFF Disables broadcast storm protection
----
ON Enables jumbo frame function
refers to Jumbo
Disables jumbo frame function
OFF
Frame
Enables the corresponding PORT Alarm. If the
port's link fails, the relay will form an open circuit
ON
and the fault LED will light up.
PORT Alarm
Disables the corresponding PORT Alarm. The
OFF relay will form a closed circuit and the Fault LED
will never light up.
ATTENTION
To actively update DIP switch settings, power off and then power
on the Ethernet Switch.

LED Indicators

The front panel of the Ethernet Switch contains several LED indicators. The
function of each LED is described in the table below.
LED Color State
On
PWR1 AMBER
Off
On
PWR2 AMBER
Off
RED On
FAULT
Description
Description
Power is being supplied to power input
PWR1
Power is not being supplied to power input
PWR1
Power is being supplied to power input
PWR2
Power is not being supplied to power input
PWR2
When the corresponding PORT alarm is
enabled, and the port's link is inactive.
- 10 -