100Basefx Ethernet Port Connection; Redundant Power Inputs; Dip Switch Settings - Weidmuller IE-SW-BL06-4PoE Series Hardware Installation Manual

100BaseFX Ethernet Port Connection

The concept behind the SC/ST port and cable is quite straightforward.
Suppose you are connecting devices I and II; contrary to electrical
signals, optical signals do not require a circuit in order to transmit data.
Consequently, one of the optical lines is used to transmit data from
device I to device II, and the other optical line is used transmit data from
device II to device I, for full-duplex transmission.
Remember to connect the Tx (transmit) port of device I to the Rx
(receive) port of device II, and the Rx (receive) port of device I to the
Tx (transmit) port of device II.
SC-Port Pinouts
ATTENTION
This is a Class 1 Laser/LED product. To avoid causing
serious damage to your eyes, do not stare directly into the
Laser Beam.

Redundant Power Inputs

Both power inputs can be connected simultaneously to live DC power
sources. If one power source fails, the other live source acts as a
backup, and automatically supplies all of the Ethernet Switch power
needs.

DIP Switch Settings

DIP Switch
- - - -
BSP
ST-Port Pinouts
The default setting for each DIP Switch is
OFF. The following table explains the effect
of setting the DIP Switches to the ON
positions.
Setting
–
Serves no function (reserved for future use).
ON Enables broadcast storm protection
OFF Disables broadcast storm protection
Description
11