PTI security systems Wireless Door Alarm System Installation And Operation Manual page 65

Slide a thin piece of ferrous metal between the magnet
and the transmitter housing - an electrical junction box
Make sure that the metal used is not copper, brass, or alu-
minum. A magnet must stick to the metal for it to work.
To test the doors, slip the metal plate between the magnet
and the transmitter housing. Hold it in position for two to three
If the door transmitter is working properly, the controller will
Door Open
show a
Door Close
If the controller does not show any activity, check the
If the controller shows an
Unknown Door Close
(The door table may not have been downloaded)
If the door table is right, the correct unit number will appear. If
not, the door table needs to be updated or the system will not
rev. 7-2017 114A3873.D
Wireless Door Alarm System
Test the door transmitters
cover works very well.
seconds, then remove it.
Door Alarm
or
event and a reference to the unit number.
transmitter installation carefully.
Unknown Door Open
, the door table reference is wrong in
the controller.
operate properly.
event followed by a
and an
60