PTI security systems Wireless Door Alarm System Installation And Operation Manual page 41

Tamper Sensor Enable/Disable
The Tamper Sensor parameter enables/disables the tamper switch.
ENABLED
When
controller if the door to the multiplexer is opened. When
the tamper sensor is ignored.
This only affects the tamper sensor on the multiplexer case.
It does not enable or disable tamper alarms from the wireless
transmitters. The factory default is
Beep with Key Press
Beep with Key Press controls the buzzer on the system. When set to
YES
, the multiplexer will produce a very short beep when a key is
pressed. Installers have an additional signal to verify entries from
the keypad. The factory default is
Date Format
The Date Format parameter controls the format of the date shown
on the display. It does not affect the date or time from the controller.
The options are
US
default is .
rev. 7-2017 114A3873.D
Wireless Door Alarm System
Tamper Sensor is:
ENABLED
*
Press
PRESS # WHEN DONE
, the multiplexer will send a tamper alarm to the
Beep with Key Press?
*
Press
PRESS # WHEN DONE
Date Format:
*
Press
PRESS # WHEN DONE
US
format and
to Change,
ENABLED
.
YES
.
YES
to Change,
US
to Change,
EUROPEAN
DISABLED
format. The factory
,
36