PTI security systems Wireless Door Alarm System Installation And Operation Manual page 42

Wireless Door Alarm System
Time Format
The Time Format parameter controls the format of the time shown
on the display. It does not affect the date or time from the controller.
The options are
Hour
.
Check in Fail Time
Check in Fail Time controls the length of time the Multiplexer gives
a door transmitter to check in before the Multiplexer assigns a
"Failed to Report"
must check in at least once during this time period. The time is set
in minutes, current factory default is 240 minutes.
37
Time Format:
12 Hour
*
Press
PRESS # WHEN DONE
12 Hour
and
Check-In Fail Time:
in minutes: 240
*
Press
PRESS # WHEN DONE
to the transmitter. Door transmitters
to Change,
24 Hour
. The factory default is
to Change,
114A3873.D rev. 7-2017
12