Installing The Quickserver; Rs-485 Connection R2 Port; Rs-485 Connection R1 Port (Only On Non-Lonworks Quickservers); Figure 9: Rs-485 R2 Connection Port - SMC Networks FieldServer QuickServer FS-QS-12 0 Series Startup Manual

QuickServer Start-Up Guide
5

INSTALLING THE QUICKSERVER

5.1 RS-485

5.1.1 RS-485 Connection R2 port

B+ A- SG

Figure 9: RS-485 R2 Connection Port

Connect to the 3 pins on the left-hand-side of the 6 pin connector as shown.
The following Baud Rates are supported on the R2 Port:
4800, 9600, 19200, 38400, 57600, 115200
For connection to RS-232 or RS-422, please refer to Appendix A.1.

5.1.2 RS-485 Connection R1 Port (only on non-LonWorks QuickServers)

Connect to the 3-pin connector as shown.
+ -
GND

Figure 10: RS-485 R1 Connection Port

The following Baud Rates are supported on the R1 Port:
110, 300, 600, 1200, 2400, 4800, 9600, 19200, 20833, 28800, 38400, 57600, 76800, 115200
Page 16 of 46