Table of Contents
Advertisement
5. MAINTENANCE (cont'd.)
5.3.3
Door Gasket Replacement
The cooking compartment door gaskets are made of
a silicone-type rubber material that is very durable but
subject to wear during normal operation. Should the gas-
ket leak, readjust the door gasket to the unit or replace
it.
Procedure—Replace Gasket:
1. Open the cooking compartment door.
2. Remove the six screws on the outside of the door,
and remove the inner door assembly.
2. Remove the eight nuts from the door gasket mount-
ing plate on the inside of the inner door assembly.
3. Remove the door gasket mounting plate and the
door gasket.
4. Install the new door gasket (see Figure 7-2 for part
number) to the mounting plate.
5. Reassemble the mounting plate with gasket to the
inside of the inner door assembly using the eight
nuts.
6. Reassemble the inner door assembly using the six
screws on the outside of the door.
NOTE
Remember that the lip on the door gasket
mounting plate must fit into the channel on
the inside edge of the gasket to insure a
proper seal.
Procedure—To Adjust Gasket to Unit:
To prevent steam leaks around the door, adjust the
gasket tension to cavity. Adjust the gasket by loosening
the six screws on top and bottom of door, move inner
door plate in or out, left side or right side, and tighten the
six screws.
M
F
I
, I
ARKET
ORGE
NDUSTRIES
NC
35 G
S
E
, MA 02149
ARVEY
TREET
VERETT
T
: 617-387-4100 T
: 91-9494
EL
ELEX
F
: 617-387-4456 O
AX
UTSIDE
6
Form No. S-4846
.
MA: 800-227-2659
-
Rev. A 11/98
5.3.4
Exterior Panel Removal
To prevent hazard in servicing the cooker, be
certain that the steam supply boiler is shut
down, the cold water shut-off valve is closed,
and the electrical disconnect circuit breaker for
the cooker/boiler unit is off before removing
side panels.
Access to all internal plumbing and electrical assem-
blies is from the bottom front and the right front. The
bottom front panel is removed by removing the bottom
screw. The panel is shown as item #25 in Figure 6-1.
The electric control panel, shown in Figure 6-3, may also
be removed as a unit by removing screws and pulling the
panel forward. Removal of the control panel is completed
by unplugging interconnecting wiring at the pin housing.
5.3.5
Water Solenoid Valve
Replacement
Replacements for the
able as complete units from Market Forge Authorized
Service Agencies. It is necessary to replace an entire
steam valve when the coil is faulty or the diaphragm
ruptures. Replacement coils are available for the water
valves. The valves are accessed as explained in Sub-
section 5.3.4.
5-2
WARNING
1
/
-inch water valves are avail-
4
Advertisement
Table of Contents
