Husqvarna PG 690 Operator's Manual page 27

6. Release the joystick.
7. Do the same procedure to the right (E).
8. To calibrate "CENTER" (F) release the joystick. The
joystick moves back to the center position (G).
MINIMUM
0% (50%)
F
CENTER
50%
MAXIMUM
100%
I
H
9. Push "OK" button (H).
10. Push the button (I) to go back in the menu structure.
11. To calibrate the vertical movement of the joystick,
select "JOYSTICK Y" in the "CALIBRATION" menu.
12. Do the same calibration procedure as "JOYSTICK X"
but move the joystick up and down.
"OPERATING HOURS"
"OPERATING HOURS" shows the total operation time
of the product in hours.
"PRODUCT INFO"
"PRODUCT INFO" shows information about the product
or the remote control.
Function menu for oscillation and offset
Oscillation prevents edges on the surface. When you
change a value in the menu for oscillation and offset, the
corrections are done after some seconds.
CAUTION: Monitor the oscillation when the
product operates near walls and edges.
Stop the oscillation when you turn the
product or operate near objects.
• "ON"/"OFF": Start/stop the oscillation. Use for
example when you turn the product. When you start
the oscillation, the same values that were used
before the stop are used.
The arrow keys on the remote control let you move
between the selections "ON" or "OFF".
1163 - 003 - 22.01.2020
Jan 05 12:45
G
REV
FWD
SPEED
0
POWER
0
OFF
• Offset: Correction of the direction of the product
displacement during operation.
The arrow keys start the oscillation. The "OK" button
on the remote control starts the offset mode.
REV FWD
SPEED
0
POWER
0
ON
• In offset mode, the arrow keys let you adjust the
offset value.
REV
FWD
SPEED
0
POWER
0
ON
• Amplitude: How wide the oscillation is.
In offset mode, the "OK" button starts the amplitude
mode. The arrow keys let you adjust the amplitude
value.
Jan 05 12:45
REV FWD
SPEED
0
POWER
0
0
m/s
Jan 05 12:45
FWD
REV
SPEED
0
POWER
0
0
m/s
4 4 1
OK
Jan 05 12:45
REV FWD
SPEED
0
POWER
0
0
m/s
4 4 1
OK
27