Husqvarna PG 690 Operator's Manual page 19

1. Pull the lock lever (A) on the handle in the direction
of the control panel and hold it in this position.
B
2. Adjust the handle (B) to an applicable operation
height.
3. Release the lock lever on the handle to lock the
handle position.
4. Loosen the 4 screws (C) on the handlebar.
D
C
5. Adjust the handlebar (D) to an applicable operation
height.
6. Tighten the 4 screws (E) on the handlebar to lock the
handlebar position.
To connect the product to a power
source
1. Connect the power plug of the product to the
extension cable.
2. Connect the extension cable to a mains outlet.
3. Engage the support frame. Refer to
disengage the support frame on page 15 .
1163 - 003 - 22.01.2020
A
E
To engage and
4. Hang the power cord on the suspension device on
the support frame to prevent tension in the power
cord.
5. Disengage the support frame.
CAUTION: When the product is connected
to a dust extractor, the dust extractor must
be connected to a 3-phase power source.
USB charger on the control panel (PG
690 RC, PG 830 RC)
The USB charger on the control panel can be used to
charge mobile devices.
• To charge through the USB charger is only possible
when the product is connected to a 3-phase power
source.
• The mobile device continues to charge if the product
stops or the emergency stop button is engaged.
• The product does not set a time limit for how long a
mobile device can be charged. Charge your mobile
device as recommended by the manufacturer of the
mobile device.
• The USB charger supplies a maximum output of
10W.
To charge a mobile device (PG 690 RC, PG
830 RC)
1. Connect the product to a 3-phase power source.
To connect the product to a power source
Refer to
on page 19 .
19