Husqvarna PG 690 Operator's Manual page 15

11. Connect the product to a power source. Refer to
connect the product to a power source on page 19 .
12. Turn the emergency stop button on the control panel
clockwise to make sure that the emergency stop
button is disengaged.
13. Make sure that you know the direction of rotation of
the grinding head and the grinding discs when you
use direction diamond tools such as Piranhas.
14. PG 690 RC, PG 830 RC: If the product is operated
manually, attach the remote control to the product.
The rear side of the remote control holder has a
To attach the remote control to the
magnet. Refer to
remote control holder on page 21 .
15. Put the support wheel in operation position. Refer to
To set the support wheel in operation position on
page 42 .
To engage and disengage the support
frame
The product has a support frame that is used to tilt the
product rearward. Also, the support frame is used as a
suspension device to hang the dust extractor hose and
the power cord on.
WARNING: Be careful when you move the
support frame. The moving parts can cause
injury.
1163 - 003 - 22.01.2020
To
1. Lift the support frame (A) a small distance.
2. Lower the support frame (B).
3. Fold up the support frame in the opposite sequence.
Diamond tools
There are many different types and configurations of
diamond tools for the product. Metal bonded diamond
tools are used for removal of material and resin bonded
diamond tools are used to polish surfaces. Select the
correct diamond tools for the surface. Speak to your
Husqvarna dealer or go to www.husqvarnacp.com for
support to select the correct tool.
Disc holder alternatives for diamond tools
• Use a Redi lock disc holder to attach metal bonded
diamond tools.
• Use a resin disc holder to attach plastic bonded
diamond tools.
Full set and half set of diamond tools
The configuration of the diamond tool segments has an
effect on the end quality of the surface. The
configuration also has an effect on the operation rate of
the product.
A
B
15