Setting The Clock - Honeywell NOTIFIER ID2000 Series Operating Manual

SETTING CLOCK SETTING CLOCK
SET NEW DATE/TIME SET NEW DATE/TIME
Setting Clock menu structure. The
available menus within this structure
depend upon the passcode and the panel
configuration.
997-434-000-4, Issue 4
May 2010
ID2000 Series Operating Manual

4.11 Setting the Clock

This procedure uses the LCD menus. The menu
structure is shown below:
ADJUST CLOCK SPEED ADJUST CLOCK SPEED
SET SUMMER TIME START/END SET SUMMER TIME START/END
This operation is required after any Time Zone change,
e.g. start/end of British Summer Time if not configured
for auto-adjust, and after the system has been fully
powered-off (in the latter case the system will start-up at
midnight on the last date on which it had been operating,
or at the time when the clock was last reset, whichever
was the later).
To set the clock:
1 From the Top Level display, press Pushbutton '3'. The
clock display will be 'frozen', and will be as shown
below with the 'seconds' part of the 'time' field of the
clock flashing on the display:
SETTING CLOCK (date) (time)
Use <− <− ↑↓ −> <− <− <−
To adjust the date and time, use the
pushbuttons to move the cursor over the field to be
changed. Use the
the value of the field to give the current date and time.
2 After all fields have been adjusted correctly, press
to start the clock running at the precise time shown,
or press
to the previous clock setting.
If the panel status is ENGINEER (i.e. the access 3
passcode has been entered), the following additional
steps are provided before the clock is started:
a. Adjust clock speed. The following is displayed:
Adjust Clock Speed (
If you press
CLOCK to run
per week (use ↑↓
Press
go slower (to determine the value to enter, measure
the increase or decrease in clock time over the course
of a week). Press
38
START CLOCK
CANCEL CLOCK RESET CANCEL CLOCK RESET
↑↓ −> to adjust, ↑↓ −> ↑↓ −> ↑↓ −>
! ! ! ! ! to end
and pushbuttons to adjust
to cancel the whole operation and return
/X)?
! ! ! ! !
, the display is:
(FASTER)(SLOWER)
↑↓ ↑↓
↑↓ ↑↓)
to make the clock go faster,
to end the adjustment.
and
by n.n seconds
to make it