Honeywell NOTIFIER ID2000 Series Operating Manual page 22

ID2000 Series Operating Manual
4 The system displays one of the prompts shown below
(depending upon whether the module is currently
active or not):
Mod. (n) - Zone (n) - (type)
Switch Module ON (
Mod. (n) - Zone (n) - (type)
Switch Module OFF (
5 Press
following prompt is displayed:
Press X to terminate test _
Pressing X will abandon the testing of that particular
module. You are then prompted with:
Use ↑ ↑ ↑ ↑ ↑ ↓ ↓ ↓ ↓ ↓ to step up/down,
If required, enter other modules for testing using the
!" keys (or enter the exact, or approximate, number
of the module). To finish testing, pressing the
a number of times will take you back to the Top Level
menu.
To switch off the module quickly, simply press SILENCE
SOUNDERS. However, if you do not want to silence
sounders elsewhere, i.e. you want them to remain on
because of an Alarm or Evacuate condition, or if the
module is non-silenceable you will have to repeat the
above sequence and press
4.8.2.2 Local Sounder Circuits
To test one of the four local sounder circuits:
1 Press 1, 2, 3 or 4 in response to the options shown in
Section 4.8.2. The system displays one of the
questions shown below (depending upon whether the
sounder is currently active or not):
Switch Sounder n ON (
Switch Sounder n OFF (
Switch Relay n ON (
Switch Relay n OFF (
2 Press
quickly, simply press SILENCE SOUNDERS. However,
if you do not want to silence sounders elsewhere, i.e.
you want them to remain on because of an Alarm or
Evacuate condition, you will have to repeat the sequence
above. If circuit 3 or 4 is configured as a relay, SILENCE
SOUNDERS will not affect it and the sequence above
must be repeated. Pressing the panel RESET
pushbutton will return all active outputs to normal.
19
/X)?
! ! ! ! !
! ! ! ! ! /X)?
to perform the test. Once in test mode, the
to select
! ! ! ! !
to stop the test.
/X)?
! ! ! ! !
! ! ! ! ! /X)?
! ! ! ! ! /X)?
/X)?
! ! ! ! !
to perform the test. To switch off the sounder
997-434-000-4, Issue 4
key
May 2010