Setting Printer Options; 3: Installing And Configuring A Keltron Printer - Honeywell XLS140 Installation Manual

Installation

Setting Printer Options

Refer to the documentation supplied with the PRN series printer for instructions on using the
printer menu controls. Set the printer options (under the menu area) according to the settings listed
in Table 3.5.
Option
Font
LPI
ESC Character
Bidirectional Copy
CG-TAB
Country
Auto CR
Color Option
Formlen
Lines
Standard
3.14.3 Installing and Configuring a Keltron Printer
Connect the remote printer to the Control Panel as follows:
1. Connect the three (3) open leads of the custom cable to the TB14 terminal block on the control
panel as shown in Figure 3.27.
2. Connect DC power from TB7 terminal block on the control panel as shown in Figure 3.27.
3. Plug the DB-25 connector end of the custom cable into the EIA-232 port of the Keltron printer.
Tighten securely.
52
DB-25 connector
on PRN series
printer (female
socket shown)
PRINTER
TX RX
Control Panel
Figure 3.26 Remote Printer Connections
Setting
HS Draft
6 LPI
ESC
ON
Graphic
E-US ASCII
OFF
Not Installed
6LPI=60
Exec 10.5
Table 3.5 PRN Setup Options
XLS140 Installation Manual Form Number 95-7673-3 P/N 51927:C 12/06/2005
Installing Remote Printers and/or CRT
Note: Outputs are
power-limited but
are not supervised.
Terminate one end of
shield at backbox
PC/CRT
REF
TX RX REF
TB14 TB15
Option
CPI
Skip
Emulate
I/O
Buffer
Serial
Baud
Format
Protocol
Character Set
Sl.Zero
Auto LF
PAPER
BIN 1
BIN 2
SINGLE
PUSH TRA
PULL TRA
PAP ROLL
Setting
10 CPI
0.5
Epson FX-850
40K
9600 or 2400
7 Bit, Even, 1 Stop
XON/XOFF
Standard
On
Off
12/72"
12/72"
12/72"
12/72"
12/72"
12/72"