Honeywell NOTIFIER ID2000 Series Operating Manual page 18

TEST
ZONE WALK TEST ZONE WALK TEST
CONTROL OUTPUT TEST
System Test menu structure. The available
menus within this structure depend upon
the passcode and the panel configuration.
ID2000 Series Operating Manual
System tests are carried out using the menus on the
LCD display (see below).
To carry out a walk test of sensors or MCPs, select '0'
and see Section 4.8.1. To carry out a Control Output
test select '1' (you will be asked for access passcode 3)
and see Section 4.8.2. To perform the daily or weekly
sensor automatic test select the appropriate pushbutton
(depends on the options available on the TEST menu)
and see Section 4.8.3.
The TEST menu also provides access to the VIEW
sensor function. VIEW sensors must be recalibrated after
replacement; select the appropriate pushbutton and see
Section 4.8.4.
TEST MODE: NETWORKED PANEL TEST MODE: NETWORKED PANEL
TEST MODE: STAND-ALONE PANEL TEST MODE: STAND-ALONE PANEL
CMX MODULES CMX MODULES
SWITCH MODULE ON/OFF SWITCH MODULE ON/OFF
SOUNDER 1 SOUNDER 1
SWITCH SOUNDER ON/OFF SWITCH SOUNDER ON/OFF
SOUNDER 2 SOUNDER 2
SOUNDER 3 SOUNDER 3
SOUNDER 4 SOUNDER 4
SENSOR AUTOMATIC TEST
REPLACE SENSOR REPLACE SENSOR
LAMP TEST
15
CANCEL TEST MODE
CANCEL TEST MODE
SWITCH SOUNDER ON/OFF SWITCH SOUNDER ON/OFF
SWITCH SOUNDER ON/OFF SWITCH SOUNDER ON/OFF
SWITCH SOUNDER ON/OFF SWITCH SOUNDER ON/OFF
DAILY AUTOMATIC TEST
WEEKLY AUTOMATIC TEST
REPLACE INDIVIDUAL SENSOR REPLACE INDIVIDUAL SENSOR
REPLACE ENTIRE LOOP REPLACE ENTIRE LOOP
SWITCH ON ALL LAMPS SWITCH ON ALL LAMPS
CONTRAST
RE-CALIBRATE SENSOR RE-CALIBRATE SENSOR
RE-CALIBRATE SENSORS RE-CALIBRATE SENSORS
997-434-000-4, Issue 4
May 2010