Honeywell NOTIFIER ID2000 Series Operating Manual page 36

ID2000 Series Operating Manual
iii Key in the required recording interval: a whole
number of seconds, permitted range 1 to 16383
(just over 4.5 hours), then press
changes to that shown below:
Sens. (n) Zone (n) (type)
Store Capacity (1-4000)
Note: If you want to terminate logging for that sensor
and release the memory allocated, just press
iv Key in the number of data values to be stored. To
calculate the total logging period, multiply this by
the 'Interval' already entered. The prompt shown
below is then displayed:
Confirm (
Press
the whole procedure.
Note: The maximum store capacity depends on the
available memory. If another sensor is already
being logged, less than the maximum of 4000
values may be available. Up to 22 sensors may
be logged simultaneously, with a combined total
of up to 20000 values stored at one time. For each
logged sensor, once allocated memory is filled,
logging continues with the oldest data being
discarded.
33
. The display
! ! ! ! ! /X)?
to complete the set-up, or
997-434-000-4, Issue 4
.
to cancel
May 2010