Honeywell NOTIFIER ID2000 Series Operating Manual page 53

997-434-000-4, Issue 4
May 2010
ID2000 Series Operating Manual
PANEL STATUS: TEST
This is the condition of the panel when a Zone has been
selected for a walk test, using the appropriate pushbutton
sequence (see Section 4.8.1 for details).
The TEST condition continues to be shown until
superseded by a higher-priority condition or until Test
mode is terminated using the appropriate pushbutton
sequence.
The LCD displays the message shown below:
(ZONE or device (no)) IN TEST
(blank) or (System Normal message) or (last tested device)
The indications of the panel and external equipment are
as follows.
LAMP indications:
Numbered zone indication (amber)
Internal sounders and
Circuits Controlled Internally: as for status NORMAL
External Devices:All CONTROL MODULES
The built-in LED indicators on the sensor(s) in the Zone
in test show 1-second-ON/1-second-OFF pulses
(possibly with intervening short pulses).
The built-in LED indicators on all other sensors and
modules should either give short pulses or be OFF
altogether, as configured.
A1 - 10
(date)
POWER (green):
TEST (amber):
All other LAMPs
should be
(time)
ON
ON
OFF
STEADY
OFF