Honeywell NOTIFIER ID2000 Series Operating Manual page 45

997-434-000-4, Issue 4
May 2010
ID2000 Series Operating Manual
PANEL STATUS: NORMAL
This is the condition of the panel when it is operational,
and there are no uncleared FIREs or FAULTs or PRE-
ALARMs, no part of the system is disabled, and no
TESTing or CONFIGURATION is being carried out. The
LCD displays, indications of the panel and external
equipment are as follows:
LAMP indications:
The LCD display in Normal Mode is below:
Status: NORMAL
(blank) or (System Normal message)
Internal buzzers:
Circuits Controlled Internally: Sounder Circuits:
FIRE, FAULT relays
External Devices:
All CONTROL MODULES should be
- unless operated by an auxiliary action.
The built-in LED indicators on all sensors and modules
should either give short pulses or be off altogether.
The 'system-normal message' is a text message specially
customised for your installation, and may consist of an
advertisement, such as the building name, or similar
information.
Note: The MUTE BUZZER, ACCEPT, EVACUATE,
SILENCE SOUNDERS, RESOUND SOUNDERS
and RESET pushbuttons each have an associated
lamp which illuminates when the button is activate,
until superceded by another pushbutton operation.
This is in addition to the indications described in
this Appendix.
PANEL STATUS: EXTINGUISHANT RELEASE
If an Extinguishing System is configured and a release
countdown begins, the LCD will display the following
momentarily on the top line every 4 seconds:
EXTINGUISHANT RELEASE: nnnsec left
A1 - 2
POWER (green) ON
All other LAMPs OFF
(date) (time)
OFF
OFF
OFF
OFF