Phone Setup; Adjust The Handset Rest - Cisco 8841 User Manual

Phone Setup

Your phone will be set up and connected to the network.

Adjust the Handset Rest

If your phone is wall-mounted or if the handset slips out of the cradle too easily, you may need
to adjust the handset rest to ensure that the receiver does not slip out of the cradle.
Figure 1.
Use the following steps to adjust the handset rest.
1. Remove the handset from the cradle and pull the plastic tab from the handset
rest.
2. Rotate the tab 180 degrees.
3. Hold the tab between two fingers, with the corner notches facing you.
4. Line up the tab with the slot in the cradle and press the tab evenly into the slot. An
extension protrudes from the top of the rotated tab.
5. Return the handset to the handset rest.
Cisco IP Phone 8841/8851 Multiplatform Phones User Guide
Adjust the Handset Rest
Phone Setup
2