Exit Pointing And Registering With The Network; Idle Mode Display; Status Messages - Hughes Strigo 4201 User Manual

Exit pointing and registering with the network

Idle mode display

Status messages

Display
HUGHES 4201
Boot Failure
Insert SIM
Reading SIM...
Enter PIN
Enter PUK
SIM Blocked
SIM Error
Unlock SIM
Chapter 3 • Using the LCD and keypad
18
H61798 Revision E
Once you have accurately pointed the terminal to the satellite, exit pointing by a
long press of the Back button. This will cause the unit to attempt to register with the
Strigo network (Note: if audible pointing tones were enabled during pointing, they
will automatically turn off once you attempt to register).
Once the terminal exits pointing, it will automatically attempt to attach to the
network and establish a data connection. During this operation it displays
"Attaching" on the upper line of the LCD.
Once it attaches and establishes a data context, the LCD displays "Data Ready" on
the upper line and the globe icon.
In idle mode, the strength of the received satellite signal is displayed by a 5-bar
indicator located in the lower right hand corner of the LCD.
Figure 8: Idle Mode Display
If user equipment is connected (via Ethernet or Wireless LAN), the lower line will
display "ADDR:" followed by the last octet of the IP address of the currently
selected user terminal. If multiple devices are attached, you can show the other
user's local IP address by repeatedly pressing the user button.
The upper level of the LCD is used for status messages and menu items. Status
messages are listed in Table 2 on page 18:
Table 2: Status messages
On screen during power up.
The terminal failed to boot.
No SIM is detected. Insert the SIM to continue.
Terminal is reading information from SIM.
A SIM PIN code is needed. (This can be entered using the front panel buttons.)
A SIM PUK code is needed. (This must be entered using the Web UI.)
The SIM is blocked due to too many SIM PIN/PUK attempts.
There is a SIM communication error.
The terminal is locked to another SIM and the SIM Lock PIN is needed. (This
must be entered using the Web UI.)
Description