Table of Contents
Advertisement
Before getting started
Quick start
GPS icon
Satellite icons
Using the Hughes 4201
Install the USIM and battery into the terminal unit and then fully charge the
battery using the supplied AC/DC converter before powering up the unit.
Press the power button for at least 2 seconds to power on the unit.
The Hughes 4201 Mobile Satellite terminal must first obtain a GPS fix by setting it up
in a location with an open view of the sky.
The GPS icon on the LCD indicates the state of the GPS information in the terminal.
The icon flashes after power up until a fresh GPS fix is obtained.
The icon is on steady when the terminal has a new GPS fix.
The satellite icons, located next to the GPS icon, indicate the status of the GPS
receiver in the terminal and the number of visible satellites.
The icons are off when the GPS receiver is off.
The icons are active when the GPS receiver is on, either flashing or steady state.
The number of icons in steady state indicates the number of GPS satellites in view.
You will need all three on solid to acquire a new GPS fix. Note that once an
Figure 2: Inserting the USIM card
Chapter 2 • Using the Hughes 4201
Chapter 2
H61798 Revision E
11
Advertisement
Table of Contents
