Web Ui Quick Start - Hughes Strigo 4201 User Manual

Web UI quick start

Chapter 2 • Using the Hughes 4201
12
H61798 Revision E
adequate GPS fix is obtained, both the GPS receiver and all of the satellite icons are
turned off and the word "GPS" should go on steady.
Figure 3: Terminal iUI (LCD)
The top line gives the compass bearing and elevation angle of the Echostar T1
satellite.
Figure 4: Compass bearing and elevation angle of the Echostar T1 satellite
Use the signal quality bar and numeric display on the lower line to help point the
terminal to the satellite. While in pointing mode, you may also activate the audio
pointing aid by a long press of the Audio/Scroll button on the right.
For best performance of the terminal it is recommended to maximize the signal
received by the terminal by adjustment of elevation and compass direction. Once
you have optimized pointing of the terminal to the satellite, exit pointing by a long
press of the Cancel/Back button. The unit will now attempt to register with the
satellite network.
Once the unit has registered and is Packet Switched (PS) attached, it will
automatically create a data connection.
Alternatively, you can connect a computer and use the Hughes 4201's internal Web
server. From your terminal equipment (e.g., PC), enter 192.168.128.100 as the URL
to access the Hughes 4201's home page.
The Terminal Status page gives you all the information you need to point and
register with the network. Once you have a GPS fix and are pointed to the satellite