Table of Contents
Advertisement
Display
Wrong SIM
Bad SIM
Getting POS...
Searching...
Point ANT
Attaching...
Ready
Data Ready
SAT Blocked
Charged
Charging
Battery Low
Batt Empty
Too Hot
Battery Hot
Reboot Req
Critical Err
Powering Off
Rebooting...
Resetting...
Upgrading...
Factory Mode
Attach Fail
GPS Comm Err
HW Failure
Menu navigation
Incorrect SIM found in this unit. The SIM inserted is not the SIM that was
originally locked to the terminal.
SIM card is invalid.
Terminal is getting a GPS position.
Terminal is searching for the satellite signal. This message alternates with
satellite bearing and elevation angle on a 3 second cycle.
Terminal is in antenna pointing mode. This message alternates with satellite
bearing and elevation angle on a 3 second cycle
Terminal is attaching to the network.
Terminal is attached to the network but no data connections are currently
opened.
The satellite data connection is active and ready for use.
The satellite signal has been temporarily obstructed, blocking the connection.
Battery is fully Charged
Battery is Charging
Battery charge level is low
Battery charge is near empty
Unit is too hot; if not corrected, a temporary thermal shutdown may occur
Battery is too hot; reduce temperature or turn off unit to avoid damage to the
battery
UT Reboot is required
A hardware error has caused a forced shutdown of the terminal.
Displayed while the Hughes 4201 is powering down
The terminal is currently rebooting.
The terminal is currently resetting to default parameters.
The terminal software is currently being upgraded.
The terminal is in a test mode and cannot be used.
The terminal failed to attach to the network.
The terminal was unable to communicate with GPS receiver.
The terminal has encountered a hardware fault and cannot continue.
From the status display, a short press of the Accept button takes the display to
menu mode and displays the first of a circular list of menu items. The keypad menu
structure is shown under Table 4 on page 22.
Use the scroll button to scroll between options and the accept button to select
options. A short press of the Back button takes the user up one level in the menu
and a long press exits the menu system and returns to the status display.
The status display is the default display, so after 30 seconds of inactivity while in the
menu system the unit reverts to the status display.
Description
Chapter 3 • Using the LCD and keypad
H61798 Revision E
19
Advertisement
Table of Contents
