Alert List] Tab - JRC JAN-7202 Instruction Manual

3.2.1.2

[Alert List] tab

On the screen of the [Alert List] tab, the equipment names and all the alerts that occurred from each
equipment (including normal states) are displayed.
All the alerts defined are displayed in a list for each piece of equipment.
Alerts concerning MFD are selected according the license. Alerts concerning equipment other than
MFD are displayed according to the definition of the BAM file and the installation status.
Information on aggregated alerts is not displayed. Information only on individual alerts is displayed.
Memo
A BAM file is a general term of the file group that is imported and expanded by the BAM interface to
construct a database of alert information.
Inhibit target alert
An alert that is not activated even if it occurred is called an Inhibit target alert.
An Inhibit target alert is specified by the BAM file and is ignored even if it occurs. An Inhibit target alert
is displayed as Disable on the [Alert List] tab screen.
(2)
(1)
(6) (7)
[1] [New Alert Occurred] and [Confirm] button
When a new alert occurs while an alert list is displayed, the occurrence of a new alert is notified by
displaying a message, [New Alert Occurred], as well as blinking the [Confirm] button.
When the [Confirm] button is clicked on, the top page of the [Active Alert] tab screen is displayed.
[2] Silence button
This button silences the alert sound.
(3) (4)
(8) (9)
3-13
(5)
(10)
Section 3 Bridge Alert Management (BAM)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27