Timer - Mitsubishi Electric MELSEC iQ-R Series Programming Manual

Timer

OUT_T, OUTH_T, OUT_ST, OUTH_ST
• OUT_T: Low-speed timer instruction
• OUTH_T: High-speed timer instruction
• OUT_ST: Low-speed retentive timer instruction
• OUTH_ST: High-speed retentive timer instruction
These instructions start time measurement when the operation result up to the OUT instruction is on. When time is up, the
normally open contact turns on (continuity state) and the normally closed contact turns off (non-continuity state).
ST
ENO:=OUT_T(EN,Coil,Value);
ENO:=OUTH(EN,Coil,Value);
■Execution condition
Instruction
OUT_T
OUTH_T
OUT_ST
OUTH_ST
Setting data
■Description, range, data type
Operand Description
Coil Timer type label
Value Value set for the timer
EN Execution condition
ENO Execution result
■Applicable devices/labels
Operand Bit
SB
Coil

Value

*1 Only K (decimal constant) can be used.
Execution condition
Every scan
Word
RX, RY, LB SW
 
 
Range

0 to 32767


G, RWw, RWr, LW


5 SEQUENCE INSTRUCTIONS
5.1 Output Instructions
5
Data type
ANY_BOOL
ANY_INT
BOOL
BOOL
Constant
K, H

*1

49