Basic Mode; Switching On/Off; Ordinary Weighing; Weighing With Tara - KERN TCKE 300-3-A Operating Instruction

8 Basic mode

8.1 Switching on/off

Switching on:

Press the ON/OFF button.
Once the displays is lit, the scales autotest will be carried out.
Wait until the weight is displayed, the scales is ready for use.
Switching off:

Press and hold the ON/OFF button until the display goes off.

8.2 Ordinary weighing


Check the zero indication [>0<], and whenever required, zero by pressing the
TARE button.

Place the weighed material.

Wait until the stabilization indicator is displayed (

Read out the weighing result.
Overload warninig
Always avoid any device overload higher than the stipulated maximum
load (Max), deducting the tara from the existing load. This could damage
the device.
The exceeded maximum load is indicated with
load or reduce the initial load.

8.3 Weighing with tara

8.3.1 Taring

The empty weight of any vessel used for weighing can be tared, pressing the button
which results in displaying the net weight of the weighed material during consecutive
weighing processes.

Place the scales vessel on the scales plate.

Wait until the stabilization indicator is displayed
vessel weight will be saved in the scales memory. The stabilization indica-
tor is displayed (
"TARE" indicates all displayed weight values are net values.

Weigh the weighed material.

Wait until the stabilization indicator is displayed (

Read out the net weight.
CKE-BA-e-2132
) and "TARE" symbol will be displayed.
).
. Reduce the scales
( ), and press TARE. The
).
17