Electronic Depth Stop (Option) - Landoll 6230 Operator's Manual

Electronic Depth Stop (Option)

1. Attach the electronic depth control mounting bracket
to the middle cross bar of the center frame using a
5/8 x 4 x 6-1/2 u-bolt and hex lock nuts (See
Figure 3-6.) See Figures 2-1 thru 2-4 for proper
placement. The depth control lever should line-up
with the depth stop mounting plate on the center lift.
ASSEMBLY INSTRUCTIONS
2. Adjust the control rod linkage to 5-1/2" length and
connect the depth control lever to the depth stop
mounting plate.
3. Route the electrical cable from the front hitch,
through the hose loops and connect to the depth
control switch.
4. Fully retract (turn clockwise) the hydraulic depth
stop, so that it does not interfere with the electronic
depth stop operation.
5. Read and follow tractor operating instructions for
setting and adjusting depth of the electronic depth
control.
3-13