Landoll 6230 Operator's Manual page 70

OPERATION AND MAINTENANCE
2. The hydraulic system is not filled with oil and should
be purged of air before transporting and field
operations. Carefully hitch the disc to the tractor and
connect the hydraulic lift hoses. Check to make sure
the tractor hydraulic reservoir is full of the
manufacturer's recommended oil. Slowly raise the
machine, and continue to hold the hydraulic lever
until all lift cylinders are fully extended. With all
cylinders fully extended remove the 1-3/8 X 10
transport lockouts (See Figure 4-3.). Store transport
lockouts as shown in Figure 4-4. Lower and raise the
unit to verify that all cylinders are working
simultaneously throughout the stroke. If the cylinders
are not working evenly or together, fully extend the lift
cylinders and continue to hold the lever to purge any
remaining air. Do not loosen any hoses or fittings.
Recheck tractor reservoir to make sure it is within
operating limits.
4-4
1-3/8 x 10 TRANSPORT
LOCKOUT
L PIN
1/8 HAIR PIN
6230translock2
Figure 4-3: Installed Transport Locks
1-3/8 x 10 TRANSPORT
LOCKOUT
L PIN
6230translock1
Figure 4-4: Stored Transport Locks
3. Always fully extend the cylinders and hold the lever
to ensure the cylinders are rephased before starting
any field operation. This will keep all cylinders in time
and frame sections level when operating.
F-440-0110 Edition