Yield Control X Or Yield Control T Installation - MAGUIRE Gravimetric Gateway LineMaster Installation Operation & Maintenance

LineMaster
XC-2 - Yield Control X or Yield Control T Installation
The XC-2 kit involves the installation of the following components:
 LineMaster Controller
 Extruder Drive Control
 Take-Off Drive Control
 Control Cabling
 Mounting hardware
 24 Volt Power Supply
 Encoder, Encoder Wheel (12 inch circumference)
 Encoder Cable
Mount the XCD-X Extruder Drive Control in your desired location.
Mount the XCD-T Take-Off Drive Control in your desired location.
Remove the front cover from the Extruder Drive Control (see General Installations Notes).
Run the Controller Cable from the LineMaster Controller's 7-pin receptacle to the Extruder
Drive Control box. The un-terminated side of the cable will be on the Extruder Drive Control
box side and should be cut to length leaving enough cable to run into the Extruder Drive
Control box and to the terminal strip.
Strip back approximately 2 ½ inches of the outer shielding from the un-terminated side of the
cable to expose the 5 wires. Run the Controller Cable into the Extruder Speed Control
Interface, through one of the two hole locations on the Control box. Use a stain relief if
necessary. Strip back approximately ¼ inch (6mm) per wire and install into the terminal strip
(see wiring diagram on the following page for exact wire locations).
Install the Encoder on the shaft of the haul off. Run the Encoder signal cable from the
Encoder back to the XCD-X Extruder Drive Control. At the XCD-X Extruder Drive Control wire
the Encoder signal cable according to the wiring diagram on the next page.
Run the Extruder Drive wire into the Extruder Speed Control Interface box and install into the specified terminal
strip as indicated in the wiring diagram.
If you are using the optional 24 volt power supply to power the Extruder
Speed Control Interface, install the power supply in a desired location. Run
a length of shielded, 2-conductor 18 gauge wire (not included in kit) from
the power supply to the Extruder Speed Control Interface and wire
according to the XC-1 Extrusion Control Wiring Diagram.
If the Extruder Speed Control Interface will be powered by your 0-10 volt Extruder Drive Cable, REMOVE the
jumper between J14 and J15 located on the On the Extruder Speed Control Interface circuit board.
If the Extruder Speed Control Interface will be powered by the optional 24 volt power supply (to provide an
isolated power source), DO NOT remove the jumper between J14 and J15 located on the On the Extruder Speed
Control Interface circuit board.
Maguire Products, Inc.
28