MAGUIRE Gravimetric Gateway LineMaster Installation Operation & Maintenance page 72

LineMaster
may assign a static IP Address, Subnet and Gateway.
Press the CE key to toggle between DHCP and static IP Address.
Using a Static IP Address - Press the CE key to toggle between DHCP and
static IP Address. When the display toggles to Static IP, use the keypad to
enter the static IP address you wish to assign the controller. Use leading zeros
and press the * key for decimal. After entering the IP, the display will go to
Network Mask (Subnet), the to Default Gateway. After entering the Default
Gateway, the display will return to Static IP. When you are finished entering
the network information, press exit to save settings and exit again to exit out of
programming mode. MLAN and G2 communicate over TCP port 9999.
WSB COMMUNICATIONS – Sets the Blender ID number
Press ( ,6,6) to enter an identification number for this particular weigh scale
blender. This I.D. number will appear on all printed reports. If you have more
than one unit, this helps to identify reports. If you are using a computer to
automatically gather data, then each controller must have a unique address.
Valid numbers are 000 to 255. When connected to a computer, do not use the
number 000 for identification.
MODBUS COMMUNICATIONS – Enable / Disable
Press (*,6,7) to enable or disable Modbus communications. Press "*" to toggle
between ENABLED and DISABLED. Press Exit when complete. Modbus
commands use TCP port 502. The Modbus register map are available upon
request or may be downloaded from our website.
Parameter Printout
Press ( ,7,7) to print a copy of all internal parameters. A printer must be
connected and ready. Up to 13 lists will print, a General list and 12 component
lists. Only components that are turned "on" will print. Four columns will print,
RAM; ROM; 200 and 900 series tables; and EEPROM. Identifying headings
print above each column.
Change Program Mode Password
Press ( ,7,8, followed by a 5 digit number) to change the PASSWORD
number for entering the PROGRAM mode. The system is supplied with the
number "22222" as the password number. If you wish to restrict use of this
mode to only yourself, you may make up your own number and enter it here. If
you forget your password number, call us. We can help.
Note: If you plan to use DHCP be aware that software connecting to the
Maguire Controller typically requires a known IP address that does not
change, therefore your DHCP server will most likely need to maintain
the same IP for the controller. To determine the controllers MAC
address, see *62.
Maguire Products, Inc.
72