MAGUIRE Gravimetric Gateway LineMaster Installation Operation & Maintenance page 58

LineMaster
LOCK Options through the G2 Yield Screen
On the G2 Yield Screen Current Throughput and Yield
can be Locked. Clicking any of the layer throughput
fields will display a keypad panel with a Lock or Unlock
button (depending on the current state). Clicking on
this button will either lock or unlock all layers. To use
G2's Lock or Unlock option, the LTP parameter in all
LineMaster (XCC) Controllers must be set to LTP
1xxxx, where the first digit in this parameter is set to a
1. Setting the LTP parameter to use this option will
de-activate (and ignore) the LineMaster Extruder
Speed Control MANUAL / LOCK switch.
Shutdown
Normal Shutdown Procedure – First switch the LineMaster Extruder Speed Control into
MANUAL position. Then rotate the ADJUST pot counterclockwise (at your desired rate of
decrease), eventually reaching zero volts (zero RPM).
Maguire Products, Inc.
58