Table of Contents
Advertisement
Maguire Products, Inc.
LineMaster
Model options are:
LIW05 (Sets LLF to 2500, HLF to 5000)
LIW10 (Sets LLF to 5000, HLF to 10000)
LIW25 (Sets LLF to 10000, HLF to 25000)
LIW40 (Sets LLF to 10000, HLF to 40000)
DISPLAY Firmware Status and Checksum
Press ( ,2,5) to display the Firmware status and checksum.
Displays the firmware status and checksum. When finished, press Exit, and
then press Exit again to exit out of Program Mode.
SET MANUAL MODE PASSWORD
Press ( ,4,5, followed by a 5 digit number) to change the PASSWORD
number for entering the MANUAL mode. The system is supplied with the
number "11111" as the password number. If you wish to restrict use of this
mode to only yourself, you may make up your own number and enter it here.
PRINTED REPORTS - Cycle-by-Cycle Printout
Press ( ,5,4) to set flag for a printout of data after each full dispense cycle.
With this flag ENABLED and with a printer on line, four lines of information
about the dispense cycle that just occurred will be sent to the printer. Press *
to toggle between ENABLED and DISABLED. This information includes
dispense weight and percentage of each component, the internal rate numbers
used by the computer to determine dispense time, and the actual dispense
time of each component. This is excellent information to track the accuracy of
each dispense cycle and the accuracy of the entire system over an extended
period of time. See: PRINTER OUTPUT for a more detailed explanation.
LIW COMMUNICATIONS – View the Blender's Ethernet IP Address, Subnet and Gateway
Note: this star function is available in controller software versions ending in /N
Press (*,6,0) to view the WSB's Ethernet IP Address, Subnet and Gateway. If
the WSB is configured to obtain an IP automatically (DHCP) through *65, then
the IP, Subnet will be whatever was assigned to the controller by a DHCP
Server on your network. If the IP address was configured manually, this will be
whatever was entered using *65. Press the * key to toggle through IP, Subnet
and Gateway. Press EXIT when done.
LIW COMMUNICATIONS – View the Blender's Ethernet MAC Address
Note: this star function is available in controller software versions ending in /N
Press (*,6,2) to view the WSB's Ethernet MAC Address. View Only.
LIW COMMUNICATIONS – Set the Blender TCP/IP Settings (IP Address, Subnet Gateway)
Note: this star function is available in controller software versions ending in /N
Press (*,6,5) to configure Ethernet IP Address Settings. Under Static IP, you
71
Hide quick links:
Advertisement
Table of Contents
