Controller Description - MAGUIRE Gravimetric Gateway LineMaster Installation Operation & Maintenance

LineMaster
Controller Description – Controls and Outputs
Front Panel

KEYPAD

DISPLAY
KEYPAD
See Keypad functions on page 66.
DISPLAY 40 Character Vacuum Fluorescent Display (VFD)
Displays the current rate, internal parameters, and other information and prompts to
assist the operator.
##.# K/h Numbers displayed are the current rate expressed in kilograms per
##.# Lb/h hour or pounds per hour. By pressing the CE key, the display will
show the raw count on upper left and the total weight of material, in
grams, in the bin at that moment. This displays for 30 seconds and
then reverts back to the main display.
EXTRUSION This is the Mode that that LIW controller is running in. Labeled as
YLDX EXTRUSION, YLDX, YLDT or YLDD and located in the lower left of the
YLDT screen. This mode is set by the *02 function.
YLDD
A=0.00V Depending on the Mode the controller is in, Pressing the CE key
B=0.00V
will display one of the following, "A=0.00V" "B=0.00V" or
A=0.00V, B=0.00V
"A=0.00V B=0.00V" with actual voltage of the extruder or
takeoff. A indicates Extruder voltage; B indicates Takeoff
voltage and A, B together (on lower left and lower right) indicate
Dual (Extruder and Takeoff voltage).
UNLOCKED Indicates if the RATE is LOCK ED or UNLOCKED.
LOCKED
*** INVALID *** Indicates:
ENTER PASSWORD Password is displayed when you press the "*" key from the normal
mode. Enter:
11111 - for MANUAL mode
22222 - for PROGRAM mode - or
Enter your own password number if you have established one.
PROGRAM In the lower Right position of the display indicates unit is in PROGRAM
mode.
INSTRUCTION [ _ _ ] This is displayed when you press the
mode. Enter a 2-digit instruction number for special tasks.
1. You pressed an incorrect key - or
2. You pressed a key for a function that is not active – or
3. 3. You are not in the right mode for this key to operate.
Maguire Products, Inc.
key from the PROGRAM
61