MAGUIRE Gravimetric Gateway LineMaster Installation Operation & Maintenance page 15

LineMaster
drive to maintain the desired product yield. The reaction of the LIW system to the process rate
change is almost instantaneous and will settle at the desired yield within 45 seconds of the
process reaching the final speed.
Once the LIW controller learns the throughput rate of a material, it is stored in the memory of the
controller. The controller can be left in the Auto or Locked mode if the same material is continued
or a similar bulk density material is used. If a new material with a different bulk density is used, the
start-up procedure must be re-initiated.
Components
LIW-XX Mass Flow Hopper (sized for the required throughput)
as7190 Surge Hopper
XCC LineMaster Control Operator Interface
XC-2T LineMaster Extrusion Yield Control w/ Line Speed Control Package
includes the following components:
 XCD-T
 aspc0910
 XCE-01
 aspc2210 Encoder Interface Cable, 100 ft.
An optional surge hopper, as7190, which mounts atop the LIW is available if the volume of
material in the transition from the mezzanine mounted blender is less than the capacity of the LIW
hopper
LIW MODEL
LIW-05
LIW-10
LIW-25
LIW-40 1,000 – 3,000
(optional)
Take-off Drive Speed Control, Analog 1-10 Vdc
LIW to Drive Interface Cable, 100 ft.
Encoder, Pulse Generator
THROUGHPUT
LB/HR
5 – 300
100 - 600
500 – 1,500
454 – 1,364
KG/HR
2.2 – 136
45 – 272
228 – 682
Maguire Products, Inc.
HOPPER CAPACITY
.3 ft 3 8.5 liters
3
.6 ft 17.0 liters
3
1.6 ft 45.3 liters
3
2.5 ft 70.8 liters
15