Table of Contents
Advertisement
No. Check item
3
Check the IP
address and link
status of IP
converters.
4
Check the optical
fiber cable
redundancy
settings of the IP
converters.
(Safety priority
operation mode
only)
5
Check the 4K
uncompressed
transmission
settings of the IP
converters.
(This check item is
only required if
operating the
system in
uncompressed
transmission
priority mode only.)
6
Check the sync
settings (Network
InputLock mode).
(This check item is
only required if
operating the
system in Network
InputLock sync
mode.)
52
Step 8: Checking System Settings and Device Connections (Checklist)
Description
Check the IP address and link status of an IP converter on the [Network] tab of the [Edit Virtual
Device] screen in Network System Manager.
For details about displaying the screen, see "Basic IP Converter Configuration Operations"
(page 33).
• Check that the IP address (1) is set correctly.
• Check that [Link Status] (2) is "Active."
If not "Active," check the optical fiber cable connections.
Note
Check the IP address and link status of both main and sub connections on all IP converters.
Check the optical fiber cable redundancy settings of an IP converter on the [I/O] tab of the [Edit
Virtual Device] screen in Network System Manager. For details about displaying the screen, see
"Basic IP Converter Configuration Operations" (page 33).
• Check that the [Enable hitless failover] checkbox is on.
Note
Check the optical fiber cable redundancy settings of all IP converters.
Check the [4K Quality] setting of an IP converter using the [Edit Virtual Device] screen > [Detail
setting] screen in Network System Manager. For details about displaying the screen, see "Basic IP
Converter Configuration Operations" (page 33).
• Check that [4K Quality] for all IP converters is set to [Uncompressed].
Check the GenLock module status on the [Physical Device List] screen of Network System
Manager.
Click [Settings] > [Physical Device] to display the [Physical Device List] screen.
• Check that [GenLock Module Status] is set to "Locked" on the source IP converters.
If not set to "Locked," reconfigure the settings as described in "Setting the Sync Mode" (page 39).
1
2
Advertisement
Table of Contents
