Keysight N5231A Installation Note page 24

Installation Procedure for the Upgrade
For "A" models, refer to
on page
For "B" models refer to
on page
Option Enable Procedure for "A" Model Instruments
1. To start the option enable utility, press UTILITY
2. Click the arrow in the Select Desired Option box. A list of available options
3. In the Select Desired Option list, click 216 - Configurable Test Set.
4. Using the keyboard, enter the license key in the box provided. The license
5. Click Enable.
"A" Model Option Verification Procedure
Once the analyzer has restarted and the Network Analyzer program is again
running:
1. On the analyzer's Help menu, click About Network Analyzer.
2. Verify that "216" is listed after "Options:" in the display. Click OK.
If the option(s) not been enabled or if Option 200 has not been removed,
contact Keysight Technologies. Refer to
Keysight" on page 4
Option Enable Procedure for "B" Model Instruments
For this step, you will need a USB flash drive.
A single license may contain more than one feature.
1. Locate the email(s) from Keysight which contain license file attachments.
24
"Option Enable Procedure for "A" Model Instruments"
24.
"Option Enable Procedure for "B" Model Instruments "
24.
Option Enable
then . An option enable dialog box will appear.
will appear.
key is printed on the license message you received from Keysight. Enter
this key exactly as it is printed on the message.
.
These emails are the result of
Information" on page
"Getting Assistance from
"Step 1. Obtain a Keyword and Verify the
12.
Service
, then
System
Installation Note N5232-90101
,