C
4
HAPTER
FIGURE 5. PVES Connector Installed on SmarTrax Valve
3. Route the 4-pin PVES connector of the valve harness to the SmarTrax valve mounting location.
NOTE:
Route the cable away from moving parts and heat sources.
4. Connect the PVES connector to the open 4-pin port of the SmarTrax valve.
5. Route the PSI connector of the valve harness to the dual POCI valve mounting location.
6. Connect the PSI connector to the pressure transducer installed in Port T1 of the dual POCI valve.
30
GVM Mako SmarTrax™ Installation Manual