JUMO mTRON T System Description page 43

Measuring, control, and automation system

Hide thumbs Also See for JUMO mTRON T:

Table of Contents

Dismounting, using the example of a router module 705040

Removing the router module from the DIN rail

Procedure:

Step

(B2)

(D1)

Activity

Remove the connection cables if required (Bus In, Bus Out1, Bus Out2).

➥ The router module, all modules on the right next to the router module, and, where appli-

cable, additional devices connected via Bus Out1 or Bus Out2 (router modules, multi-

function panel) are isolated from the system bus.

If required, use a screwdriver to release the wired terminal (D) of the router module (A) and

pull off toward the front (D1).

➥ The connection to the voltage supply is isolated.

Fully release the end bracket (B) using a screwdriver (B2), press upward from below, pivot

toward the front, and remove from the DIN rail.

Note: The end bracket does not need to be removed from the DIN rail if there is sufficient

space to the side to move it at least 10 mm to the left.

(B)

(A)

(A3)

(D)

(A6)

(C5)

5 Installation

(A)

(A4)

(C)

Table of Contents