JUMO mTRON T System Description page 49

Mounting the module insert
Step
1
2
3
4
NOTE!
When mounting the module insert, ensure that the snap holders (under the grooved surfaces)
audibly snap into place.
NOTE!
The availability of the system can be increased through the storage of module inserts.
Activity
Affix the new nameplate in place of the old nameplate (C) in the case.
Hold the new module insert (B) at the grooved surfaces on the top and bottom and insert
them into the case (D). For this purpose, ensure that the board of the module insert slides
into the guide rails of the case.
Reattach the wired terminal strip (A).
Reconnect the connection cables if required (Bus In, Bus Out1, Bus Out2).
5 Installation
49