Mounting In A Panel; Multifunction Panel - JUMO mTRON T System Description

5.4

Mounting in a panel

5.4.1

Multifunction panel

Mounting a multifunction panel 840 (705060)
Procedure:
Step
1
2
NOTE!
The provided template is to be used to create the panel cut-out. This is the only way to guar-
antee optimum positioning of the multifunction panel.
(A)
(B2)
(B)
(B)
Activity
Insert the device (A) into the panel cut-out (A1) from the front until the two side spring balls
(B) click into place (B2). The spring balls facilitate the mounting, but do not replace the fas-
tening elements (step 2).
Insert the fastening elements (C) into the recesses of the case (C3) and use a screwdriver
(D) to evenly clamp them against the rear side of the panel with a torque of 0.5 Nm (D4).
(A1)
(B2)
5 Installation
(C)
(C)
(C)
(C)
(C3)
(C3)
(C3)
(D4)
(D)
(C3)
(C3)
(C)
(C3)
(C)
(C)
(C)
(C3)
(C3)
45