Table of Contents
Advertisement
Electrical Control Wiring
Electrical Wiring
•
•
•
Unit Connecting and Communication Cable
•
•
•
•
•
Electrical appliance
box cover (1)
Figure 16.
AMS-SVX02A-EN
Attention All indoor units must be powered by the same
power supply system.
See attached Wiring diagram for electrical working.
Only professionals can carry out all installations.
Please take earthing measures.
Connect the wiring (communication):
Open the electrical appliance box cover (1) insert the wiring (communication) into rubber
bushing A and press them with a cable clip respectively.
Wiring according to indoor circuit diagram.
Fix the cable clip after completed.
Wrap the wire with small sponge (it is necessary for prevent condensation formation).
Press it with the cable clip after completed and then install the electrical appliance box
cover (1) and (2).
Connect 3-core rubber wire with corresponding terminal of the 3-pin terminal board.
Single phase
L
N
(to Power)
(3-pin terminal board)
3 core rubber wire
Cable clip
Rubber ring
through the wire
Cable clip
Hereby, seal it to prevent
water entering.
Rubber ring through the wire
Electrical appliance
box cover (2)
19
Advertisement
Table of Contents
